Crankshaft snout drilling fixture tool 235 261 283 327 194 230 250
Use this to help drill the snout of cranks on 194 230 250 engines. Also works on SBC 283 327 as well for 235 261
The cranks are not drilled from the factory and adding the 7/16 bolt hole will aid you on installation of the balancer and retention of it.
Precision made to fit on the end of the crank. The fillings drop out the side while drilling. A drill bushing is used for perfect alignment of the drill during drilling.
This procedure can be performed on a assembled engine. The tool will fit on the snout. Be sure to plug the seal hole with a rag and direct the slot to the down position for chip discharge.
Drill 1.5 deep.
Best to drill when crank is out of engine. I bolt the flange side to the flywheel/ flexplate to make it safely stand on end for drilling with hand drill.
Use a "W" drill bit and 7/16-20 tap