Performance Cylinder Head #2 SOLD
SOLDThis head is a customers that was sent in for a few repairs. The shop he had it at installed the lump kit incorrectly on the top of ports. This has now been corrected. The prior shop also did not chamfer the rocker stud bosses and one cracked when the bolts were tightened. The correct chamfer is now there, extra sealant has been applied and there should no problems with street rpm's and spring rates. The head has had .080 removed from deck to increase compression. It has 61CC chambers.
Originally used on 250/292
Specs
1.94/ 1.6 Stainless valves
New guides
Viton seals
Hardened exh seats
7/16 screw in rocker studs
Setup for 5/16 pushrods
Performance spring kit setup to handle upto .535 lift
61CC chamber
Chamber reworked to promote intake valve flow
Bolt in lump kit installed
LightlyPorted intake and exh
Clean cut surfaces on intake/ exh flange and clean decked surface.
This head is ready to run